|
|
|
Selecting Parts Using the Zone Navigation Tab
The Zone Navigation tab provides access to all of the standard vehicle parts for the selected vehicle. Parts are grouped according to vehicle zone, also referred to as sheets. By default, zones and the parts within each zone are sorted according to their ID but you can change this by right-clicking in the tab area and selecting an option. You can sort both the zones and the parts in each group alphabetically 
or by ID/guide number 
.
- Click the tab. The system displays all the standard parts for the zone in Vehicle Drawings Panel.
- Expand a zone by clicking
. - Click the desired part. The system displays and highlights the selected part in the Vehicle Drawings Panel, as shown below. You can now select repair and paint methods from the Repair Panel. Refer to Selecting and De-selecting Repair and Paint Methods.
Notes:
- If you select a part that conflicts with the current model option selections, the system will display the Conflict dialog box. This dialog box will prompt you to make selections to resolve the conflict. Refer to Resolving Conflicts for more information.
- If there are several options for the part you selected, the system will display the Selection of Multiple Parts dialog box. You must select the desired part in the dialog box. You can do this in one of two ways. You can click the part to highlight it and then click or you can simply double-click the part.
- When you click a part in a graphic, all possible repair methods for that part are shown in the Repair Panel. Refer to Common Repair Methods for more information.
- Depending on the width of the Zones Panel, the system might not display the entire zone or part description. To view the description in full, you can either increase the size of the panel or place the cursor over the zone or part to view a tooltip showing the full description. For more information about increasing the size of the panel, refer to the section Zones Panel in Understanding the OnePad Interface.
- If configured, you can quickly determine whether a part exists in more than one vehicle zone by clicking 
in the Repair Panel. This opens the Search Results dialog box, which shows the zones the part belongs to. If you wish to switch to a different zone to capture the part in that zone, either double-click the zone or click the zone to highlight it and click .